Warm Water Underfloor Heating Pumps & valves

Pumps and valves for warm water underfloor heating systems.

Untitled Button
Grundfos A Rated Pump UPM3

Grundfos A Rated Pump UPM3

  • £148.34
Wilo Pump A Rated Pump

Wilo Pump A Rated Pump

  • £131.83
Bastion Pump

Bastion Pump

  • £99.79
Heatmiser TA230 Actuator

Heatmiser TA230 Actuator

  • £17.05
230v Actuator

230v Actuator

  • £11.77
Pressure Gauge End Unit

Pressure Gauge End Unit

  • £10.10
Ball Valve with Temp Gauge

Ball Valves with Temp Gauge

  • £26.70
HEAT219058 - 22MM Direct Heatguard UFH

HEAT219058 - 22MM Direct Heatguard UFH

  • £81.52
HEAT115002 - 28MM Heatguard UFH Mixing Valve

HEAT115002 - 28MM Heatguard UFH Mixing Valve

  • £166.65
Auto Air Vent Unit

Auto Air Vent Unit

  • £10.10
22mm 3 Port Motorised Zone Valve

22mm 3 Port Motorised Zone Valve

  • £54.38
22mm 2 Port Motorised Zone Valve

22mm 2 Port Motorised Zone Valve

  • £52.97


Frequently Asked Questions

What our customers most commonly ask us about

  • What is the purpose of a circulation pump in an underfloor heating system?
  • A circulation pump moves warm water efficiently through your underfloor heating system. It creates the pressure needed to push water from your heat source, through the manifold, and into all heating circuits. Our energy-efficient pumps are designed specifically for underfloor heating applications, providing reliable performance while minimising electricity consumption. The correct pump size depends on the total pipe length and number of heating zones in your system.
  • When would I need a mixing valve for my underfloor heating?
  • Mixing valves blend high-temperature water from your boiler (typically 70-80°C) with cooler return water to achieve the ideal temperature for underfloor heating (typically 35-45°C). This prevents overheating your floors, which could damage floor coverings and reduce efficiency. Thermostatic mixing valves automatically adjust the mix ratio to maintain a consistent flow temperature, working alongside your controls & wiring to ensure safe operation.
  • Do I need an air separator in my underfloor heating system?
  • An air separator is highly recommended for all underfloor heating systems. Air trapped within the system can cause reduced efficiency, cold spots, and increased noise. Our automatic air separators continuously remove air bubbles from the circulating water, preventing these problems. They're typically installed at the highest point in the system or near the boiler connection. For best results, air separators work well when paired with proper insulation to maintain optimal operating temperatures.
  • What's the difference between a 2-port and 3-port motorised valve?
  • Motorised valves control water flow within your heating system. A 2-port valve simply opens or closes to allow or prevent flow, making it ideal for controlling individual heating zones. A 3-port valve can direct water between two different circuits, commonly used to prioritise hot water heating over space heating. Both types connect to your heating controls and operate automatically based on temperature requirements. For complex installations, several motorised valves may be needed alongside your primary manifold setup.
  • How do I know if I need a system filter for my underfloor heating?
  • A system filter is strongly recommended for all underfloor heating installations. It captures debris, sludge and magnetic particles that could otherwise cause blockages or damage to components. This is particularly important for underfloor heating as the small-diameter pipes are more susceptible to blockages than traditional radiator systems. For new installations, a filter helps remove manufacturing debris, while in existing systems, it prevents the accumulation of corrosion particles.